-3-
Important Safety Warnings
The Smart Roller Shutter Opener described in this
manual is designed for the automation of commercial slat
shutter doors. Any other use is considered improper and
will void the warranty.
WARNING:
You are carrying out operations on machine systems
classified in the automatic gates and doors category and
as such failure to comply with the relevant safety rules
may result in serious personal injury and/or property
damage and/or death. Reference to the safety rules can
be found on pages 2-4 of the owners manual and should
be read and understood prior to installation.
Only qualified personnel should install and service the
equipment. It is the responsibility of the installer to adhere
to all relevant safety standards.
The Smart Roller Shutter Opener is designed and
manufactured to meet all current Australian standards
and it is essential that the installer also installs the
equipment in accordance with all local and Australian
regulations.
Unqualified personnel or those who do not know the
occupational health and safety standards applicable
to automatic gates and doors category must under
no circumstances carry out installations or implement
systems.
Persons who install or service the equipment without
observing all the applicable safety standards will be
held responsible for any damage, injury, cost, expense
or claim whatsoever suffered by any person as a result
whether directly or indirectly from failure to install the
system correctly and in accordance with the relevant
safety standards and installation manual.
For a more detailed list of the Safety Warnings and safety
issues associated with the installation and use of a Smart
Roller Shutter Opener refer to the safety warnings in the
OWNERS MANUAL.
No
Package
Part
1
Motor
No Description
Qty
1
Motor
1 Set
2
Transmitter
2 Pcs
3
Manual Operation Chain
1 Pc
4
Motor Mounting Bracket
1 Pc
5
Logic Controller
1 Pc
4
Logic Controller Mounting Hardware
1 Set
5
Motor Connector Cable
1 Pc
6
Installation Manual
1 Pc
7
Owners Manual
1 Pc
Contents
Description
The Smart Roller Shutter Opener requires a 240V AC
50Hz power input. The 24V DC motor can provide remote
control and automatic modes for operation. When the
door is in operation, movement can be interrupted by
activation of the safety inputs (transmitter, wall switch (if
fitted) and photo beams (if fitted).
An encoder sets open and close positions and braking
during the end of the travel cycle reducing speed and
noise.
A 433.22MHz radio receiver is built into the circuit board
and the rolling code is memorised with the self-learning
technique. As an alternative to the built-in receiver the
unit will accept any of the range of stand alone radio
receivers. The unit has been designed to provide
maximum reliability, safety and flexibility of use.
IMPORTANT:
Before starting to install the unit read all of the
instructions carefully and make sure you are familiar
with the safety warnings included in this manual and
in the OWNERS MANUAL.
© June 2009 Smart Openers Pty Ltd
