3. INSTALLATION
This chapter describes how you to install this mower.
Before starting the installation, read the previous
Read the whole of this chapter before starting the
installation. How the installation is made also affects
how well the mower will work. It is therefore important
3.1 Preparations
Training
- Read the instructions carefully. Be familiar with the
proper use of the mower.
controls and the
- Never allow people unfamiliar with these instructions
the mower. Local regulations
or children to use
- The operator or user is responsible for accidents or
to other people or their property.
hazards occurring
3.2 Hardware adjustments
Blade adjustment
The mowing system used by this mower is based on
an effective and energy efficient principle. Unlike
normal lawn mowers, the mower cuts the grass instead
Rain sensors on the mower is optional
(See P14-5.12 RAIN),
we recommend you allowing the mower to mainly mow in
dry weather to obtain the best possible result. Even
though the mower can mow in rain, wet grass easily
collects on the
mower and the risk of slipping on steep
The blades must be in good condition to obtain the best
mowing result. In order to keep the blade sharp for as
long as possible it is important to keep the lawn free
from branches, small stones and other objects
3. INSTALLATION
chapter 2. Presentation.
the installation carefully.
to plan
may restrict the age of the operator.
of striking it off.
slopes is greater.
(especially the objects less than 6cm height). Please fill
up small holes and even out small mounds to make sure
lawn is flat.
How to adjust the cutting height:
1.Press the clamshell and open it.
2. Rotate the adjusting knot to adjust the cutting height.
Cutting height from 2.5cm to 6cm.
3. Closed the clamshell.
Cutting height explanation: take 3cm level for example.
3.3 Charging station installation
- Choose best installation place, please make sure
no magnetic interference and no
it is flat, no water,
station.
obstacle in the front of charging
- Please fix the charging station on horizontal place.
Charging
station
best
install
place
:
1. Make
sure
it is flat
2. No
magnetic
interference
3. No
water and far away from puddle
4. No
obstacle
in
front of charging station
- Lay virtual wire
charging station.
- Fix the charging
stakes by
IMPORTANT INFORMATION
Before fix the charging station on the lawn, please
examine the lawn and decide the best location where
is easy for the mower to find the station for recharge.
in the middle of
station with four
IMPORTANT INFORMATION
Do not tread or walk on the charging station plate.
3CM
Grass
Height
Cutting height: 3cm
Adjusting knob
X
X
OK
- 6 -
3cm
Peg
hammer.
