Smart Robby TC-158N, User Manual

3. INSTALLATION

- Use the virtual wire to isolate areas inside the working

islands around obstacles that can 

 area by creating 

flower beds and

not withstand a collision, for example, 

   fountains. Run the wire out to the area, route it around 

pegs are used, the wire should be laid under 

route. If 

return route. When the virtual  

the same peg on the 

  wire to and from the island with a maximum distance

  - If protected obstacles are grouped closely together

  isolate them individually. Continuous virtual island
  if obstacles are close to edge, leave them out of the 

   mowing area.  

Virtual wire

Root

Max: 1cm

Max: 1cm

Virtual wire

Max:20cm

Max: 1cm

 35cm

Min: 2m

   the area to be isolated and then back along the same  

  of 1cm, the mower can drive over the wire. 

- The distance between charging station and virtual

loop should be 2 meters at least. 

- A maximum distance between the wire and tree root is

20cm.

- Joining the virtual wire .
   If the virtual wire is not long enough
   and needs to be spliced: Use supplied 
   wire connector. It is waterproof and 
   gives a reliable electrical connection.

   To splice: Insert both cable ends in the
   connector. Now press down the button on 
   top of the connector fully. Use a pair of
   pliers or the like, as the button on the
   connector is difficult to press down by
   hand.  

- Care must be taken not to create a corner sharper 
  

degrees when setting up virtual wire. 

shorter than 90 

degrees can cause the 

A corner sharper less than 90 

  mower to lose track of virtual wire. We can make 

Correct corner set up,
using several angle to
avoid an angle of less
than 90

°.

Greater than 
2m

Proper setup in sharp corners

Incorrect corner
      setup

  greater than 90 degrees corner like follow picture
  shows.

- 8-

Virtual wire connecting

Greater
than 2m

Tree with hole or flowers 
around require placing a 
wire around it

1cm