B/S
C / F
2. Fixed point measurement: Pull the trigger and
aim the thermometer to forehead for measurement
(as figure 3 ).
(Figure 5)
(Figure 4)
E. Temperature unit
F. Temperature reading
(Figure 3)
3. Unit diagram description
(1) Measurement trigger: When pulling the
trigger LCD display SCAN icon and temperature
reading , At the same time with HOLD icon. Every
time pulling the trigger obtain a data.
Built-in auto power off in 10 seconds.
(2) Celsius and Fahrenheit selection and down
adjust button.
(3) B/S: body inside / body surface setting button
(4) Back-light On/Off and up adjust button
(5) LCD display(show as figure 2)
(6) Battery door
Repeatablility
Response time
1 s ec
Emissivity
Resolution
0.95 pre-set
0.1
℃
Ambient operation range 0 to 40
℃
(32 to 104
℉
)
Relative humidity
10-95% RH non-condensing,
@ up to 30
℃
(86
℉
)
Storage temperature
-20 to 60
℃
(-4 to 140
℉
)
without battery
Weight/Dimension
130g; 146 x 80 x 38mm
Power supply
Battery life(alkaline)
12 hours
Specification
Temperature Range
Accuracy
±
0.2
℃
(testing environment
temperature23
℃±
3
℃
)
4.Operation instruction:
(a)Body inside: 30 to 45
℃
(86
℉
to 113
℉
)
Body surface: 25 to 60
℃
(77
℉
to 140
℉
)
(b)Install 2*1.5V AAA battery correctly,t hen c lose
b
attery door, pull the trigger to turn on. LCD display
reading with SCAN icon(every measurement will
takes 1 to 2 seconds), after release the trigger then
the reading will be hold .
(c)Temperature unit selection: In normal status,
the default unit is Celsius, press
℃
/
℉
button will
turn into
(d) The default setting is back light off, press
button will turn on the back light.
(e) The default measurements is body inside
measurements, Hold down B/S button and then
well switching to body surface measurements.
LCD display , Without it, express body surface
measurements.
(f) The thermometer will auto power off in 20 seconds
without any operations.
(g) Using life: Over hundred thousand times in
normal measurement.
Fahrenheit.
Maintenance
1) Lens cleaning: Blow off lose particles using
clean compressed air. Gently brush remaining
debris away with a moist cotton cloth.
2) Case cleaning: Clean the case with a damp
sponge/cloth and mild soap.
Note:
1) Do not use solvent to clean lens.
2) Do not submerge the unit in water
3) This products is only used for measure
human body's temperature by test the
people's forhead..
(2)
(1)
(4)
(5)
(3)
(6)
G. Body surface measurements icon
Body surface:
25 to 60
℃
(77
℉
to 140
℉
)
Body inside: 30 to 45
℃
(86
℉
to 113
℉
)
when less than 30
℃
, display
“
”
when over 45
℃
, display
“
”
2*1.5V AAAbattery
±
0.1
℃
