P.16
User Guide
1.
Rapidly press AUX twice. While the remote’s LED is flashing, press
to remote start the
vehicle.
Note: The AUX 2 output can be activated by pressing the button.
Engine
Run
Time
On a gas engine, the Remote Car Starter can be programmed to run the engine for 3, 15, or
25 minutes (15 minutes by default). On a diesel engine, the Remote Car Starter can be
programmed to run the engine for 8, 20, or 30 minutes (20 minutes by default).
Turbo
Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine.
If your vehicle has an automatic transmission, proceed as follows to set the system to Turbo Mode:
1.
With the engine running, make sure to release the brake pedal and press the
,
or
button on the transmitter until the parking lights come ON.
Note: SmartStart™ can be setup to use the SmartStart™ icon to activate Turbo mode.
2.
Remove the ignition key from the ignition switch. The engine will continue running.
3.
Exit the vehicle and close all doors, hood and trunk.
4.
Press the
button; this will lock the doors, arm the OEM-style alarm (if configured) and
confirm that the vehicle is in Turbo Mode.
5.
The engine will shut down after 60 seconds.
If your vehicle has a manual transmission, follow all steps of the Ready Mode routine (page-9) to
activate Turbo Mode. At the last step,
•
Press
to lock the doors and have the engine shut down after 60 seconds;
The parking lights will flash 3 times and remain lit.
The OEM-style alarm and starter kill (if configured) will be armed.
•
Press to unlock the doors and have the engine shut down after 60 seconds;
The parking lights will flash 3 times and remain lit.
•
Press to shut down the engine without affecting the doors.
Note: The vehicle will enter Ready Mode once the engine run time expires.
“Home
Valet
TM
”
Mode
If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if
the vehicle is parked indoors, there is no danger of it starting accidentally by remote control. If the
vehicle has a manual transmission, it should be set into ready mode before activating the Home
Valet™.
Note: Once the Home Valet™ Mode is activated, the vehicle will not start by remote, but the OEM
alarm functions will remain active.
To put the system into Home Valet™ mode:
1.
Press the
or
button.
2.
Within 3 seconds, press the
and
buttons simultaneously until the transmitter
beep once and display
icon on the LCD screen.
