User guide
P.13
x
To
disarm
the OEM-style alarm, press the
button on the transmitter.
-To stop the horn from sounding if the OEM-style alarm is triggered, press the
or
button, or put the system in and out of
Valet Mode
(page-8)
Car Finder
If configured by your installer, the Car Finder option will help you locate the vehicle by sending a
pulsating signal through the horn. To hear the signal, press and hold the
or
button. This
will produce a pulsating signal for the time you keep the button pressed.
Intrusion Codes via horn
The system monitors the following:
x
Doors
x
Hood
x
Ignition
Note:
If an intrusion has occurred the HORN will sound for a maximum of 1minute.
If an intrusion has occurred and
pressed, the horn provides an intrusion code corresponding to
the type of intrusion that occurred.
1x = power interruption
4x = Doors intrusion
3x = Hood
6x = Ignition
P.4
User Guide
Using the Remote Control
Your Remote Car Starter is equipped with a 5-button multi-channel remote control. It can operate
two independent vehicles equipped with a Remote Car Starter (see
Multi-Car Operation page-12
,
for second-car transmitter functions).
The functions of the transmitter are as follows:
(!) AUX:
Stops the engine if
pressed for less than 3 seconds
or triggers Panic mode if
pressed for more than 3
seconds.
LOCK:
Locks the doors and
arms the STARTER KILL.
START
: Remote starts the
engine or gets the system into
Cold Weather mode if pressed
for 3 seconds.
Note:
Icon may vary.
UNLOCK
: Unlocks the doors
and disarms the STARTER
KILL. Activates the AUX 1
output if priority door access is
configured.
TRUNK:
Opens the
TRUNK or activates the
AUX 3 output
Note:
Pressing the
LOCK
and
UNLOCK
buttons simultaneously will activate the
AUX 2 output.
Vehicle Presets
Heater
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, should not be left on
HIGH
. It
is recommended to leave the settings on
LOW
or
MEDIUM
instead.
Windshield Wipers, Radio & Headlights
Certain vehicles require the radio and / or windshield wipers and / or headlights circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wipers and headlights switches are
OFF
. Leaving the headlights switch
ON
on certain
types of vehicles could cause them to remain
ON
even after remote starter shutdown, resulting in a
dead battery.
Arming and disarming the Starter Kill
This added security feature will prevent the vehicle from starting with the Ignition key when the
starter kill is armed. If the system was installed with the starter kill option, you will not be able to
start the vehicle with the key unless the system has been unlocked first or put into
Valet Mode
(page-8).
