User guide
P.9
Panic Mode
Note:
Panic mode can only be activated if the horn has been adequately configured by the
installer.
In an emergency situation, you can activate panic mode by pressing and holding the
STOP
button
for more than 3 seconds, until the horn starts honking. If the vehicle is under a remote start, the
engine will shutdown automatically before setting off the horn. You can stop the horn by pressing:
(this will lock your doors and deactivate panic mode)
,
or
(this will unlock your doors and deactivate panic mode).
Furthermore, the panic mode can be stopped by activating
Valet Mode (page-8)
* Panic Mode will automatically shut down after 30 sec.
Quick Lockout
TM
(Also called
Secure Panic
.) For fast protection in emergency situations, the system will
LOCK
all
doors when you press the brake pedal while you hear the sound signal. (
Quick Lockout
is only
available when
panic mode
has been set off.)
Cold Weather Mode
If the vehicle has a manual transmission, Ready mode
(page-5)
should be set before entering Cold
Weather mode. When Cold Weather Mode is active, the engine starts every 2 hours and runs for
3 minutes (or for 8 or 20 minutes with diesel engines). Cold Weather Mode automatically ends after
24 hours (or 12 starts).
To enter Cold Weather Mode:
x
Press and hold the
button for at least 3 seconds
x
The parking lights will flash for 2 seconds, pause, then
flash 3 times.
To exit Cold Weather Mode, do any one of the following actions:
x
Open the hood.
x
Start the engine by remote.
x
Turn the ignition key to the
IGNITION ON (RUN)
position.
x
Press and hold the
button until the parking lights come
ON
for 2 seconds, pause,
and then flash once.
If Safe Start is enabled, you can activate Cold Weather Mode by:
x
Pressing and releasing the
button, then, pressing and holding the
button until the
parking lights flash 3 times.
To verify whether the system is in Cold Weather Mode (automatic transmissions only):
x
Press the brake pedal:
x
If the vehicle is in cold weather mode, the parking lights will remain
ON
while the
brake pedal is pressed.
Extended Run Time
With the vehicle running under a remote start, pressing and holding the
button for more than 3
seconds will reset the run time counter to zero and restart the run time cycle from the beginning.
x
The horn (if programmed) will honk once;
x
The parking lights will flash slowly 3 times then remain lit.
To stop the vehicle at any moment, simply press the
STOP
button.
This procedure can only be
carried out once per remote start.
P.8
User Guide
2.
Open and close all doors.
3.
You have 1.5 minutes (or 3 minutes) to press on the brake pedal, to get in gear and
drive off.
Note 1:
Pressing on the brake pedal after the allocated period will shut the engine down.
Note 2:
The engine will continue running until the user re-enters the vehicle or until the expiration
of the engine run time.
Note 3:
If the pre-programmed run-time expires or if the user shuts down the engine remotely, the
vehicle will enter Ready Mode.
Caution!!
Do not leave children or pets unattended in a vehicle standing in Idle Mode.
Valet Mode
When the vehicle is in Valet Mode, the remote starter and alarm functionalities are disabled. If the
vehicle needs to be serviced, or if you park it indoors, the Valet Mode will prevent the engine from
being remote-started accidentally.
Any of the following features will put your remote car starter into Valet Mode:
Ignition Valet:
This feature allows you to put your system into Valet Mode by using
the ignition key.
Remote valet
: This feature allows you to put your system into Valet Mode by using the
transmitter.
To put the system into Valet Mode
To put the system into Valet mode using the KEY (Ignition Valet Mode):
1.
Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times
successively into the IGNITION/RUN and OFF positions.
2.
The parking lights will flash three times.
3.
Turn the ignition OFF.
4.
The LED on the antenna will come ON solid to indicate that the vehicle has successfully
entered Valet mode.
To put the system into Valet mode using the TRANSMITTER (Remote Valet Mode):
1.
Press the
and
buttons simultaneously until the parking lights flash three times.
2.
The LED on the antenna will come ON solid to indicate that the vehicle has successfully
entered Valet mode.
To take the system out of Valet Mode
To take the system out of Valet mode using the KEY (Ignition Valet Mode):
1.
Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times
successively into the IGNITION/RUN and OFF positions.
2.
The parking lights will flash twice.
3.
Turn the ignition OFF.
4.
The LED on the antenna will flash quickly to indicate that the vehicle is now out of Valet
mode.
To take the system out of Valet mode using the TRANSMITTER (Remote Valet Mode):
1.
Press the
and
buttons simultaneously until the parking lights flash twice.
2.
The LED on the antenna will be OFF.
The system will warn you if someone attempts to remote start the vehicle while in Valet Mode. The
parking lights will turn
ON
then
OFF
, then Flash
twice
.
