User guide
P.9
To exit Cold Weather Mode, do any one of the following actions:
1.
Open the hood.
2.
Start the engine by remote.
3.
Turn the ignition key to the
IGNITION ON (RUN)
position.
4.
Press and hold the
button until the parking lights come
ON
for 2 seconds, pause,
then flash once
.
OR
x
If
was programmed as
LOCK
&
UNLOCK
by your installer
,
press and hold the
button until the parking lights come
ON
for 2 seconds, pause, then flash once.
To verify whether the system is in Cold Weather Mode:
x
(Automatic transmissions only)
Press the brake pedal: If the vehicle is in Cold Weather
mode, the parking lights will remain
ON
while the brake pedal is pressed.
PanicMode
Note:
Panic mode can only be activated if the horn has been adequately configured by your
installer.
In an emergency situation, you can activate panic mode by pressing and holding the
for
more than 3 seconds, until the horn starts honking. If the vehicle is under a remote start, the engine
will shutdown automatically before setting off the horn. You can stop the horn by pressing
Furthermore; the panic mode can also be stopped by activating
Valet Mode (page 8)
Panic Mode will automatically shut down after 30 sec.
QuickLockout
TM
(Also called
Secure Panic
.) For fast protection in emergency situations, the system will
LOCK
all
doors when you press the brake pedal while you hear the Horn sounding. (
Quick Lockout
is only
available when Panic mode has been triggered.)
AdvancedFeatures:Installationprogrammable
Options
The Remote Car Starter was designed with flexibility and OEM integration in mind. With its
programmable options, this unit can single-handedly control nearly any electrical system in your
vehicle.
Caution: The programming of your system should be left to a professional. Changing any one of
the settings may affect the operation of your Remote Car Starter. Please note that the following
programmable options may require additional parts and labor.
IgnitioncontrolledDoorLocks
This is an added security feature. If your Remote Car Starter was installed with the Ignition-
Controlled Door Locks option, the doors will automatically lock as soon as the ignition key is turned
to the
IGNITION ON (RUN)
position while the brakes are pressed. The remote car starter will also
lock any door that was unlocked and opened (then closed) the next time the brake pedal is pressed
(only when doors are monitored). When the key is turned to the
OFF
position, the doors will
automatically be unlocked.
P.4
User Guide
UsingtheRemoteControl
Your Remote Car Starter is equipped with a 2-button multi-channel remote control that can be
configured into 2 different functions.
Default remote function:
x
button:
STOP;
x
button:
START;
x
&
buttons (together):
TRUNK
release.
Alternate programmable remote function:
x
button:
LOCK/UNLOCK;
x
button:
START/STOP;
x
&
button (together):
TRUNK
release.
VehiclePresets
Heater
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, should not be left on
HIGH
. It
is recommended to leave the settings on
LOW
or
MEDIUM
instead.
WindshieldWipers,Radio&Headlights
Certain vehicles require the radio and / or windshield wipers and / or headlights circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wipers and headlights switches are
OFF
. Leaving the headlights switch
ON
on certain
types of vehicles could cause them to remain
ON
even after remote starter shutdown, resulting in a
dead battery.
RemoteStartingYourVehicle
SettingYourVehicleintoReadyMode
If your vehicle has a manual transmission you must read the following indications. The unit must
first be set to Ready Mode in order to start the vehicle by remote. If the unit is not set to Ready
Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on the
option that was selected by your installer. Therefore, you must follow the appropriate procedure
between the two described below in order to set your vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.
The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is
pressed, if the parking brake is disengaged or if the ignition key is turned to the
IGNITION ON
(RUN)
position.
