PMWT-660/680 Installation Guide
5
In the absence of such an outlet, you must route the projector cables through the projector mount
and behind the interactive whiteboard, as described on page 16.
Installing the Wall Mounting Hardware in Drywall
1. Using the provided template, mark the anchor hole locations with a pencil. Use a four-foot
level to verify that the template is level.
If you would like to install the interactive whiteboard at the recommended installation height,
make sure the
lowest
anchor holes are at least:
–
72 3/4" (184.8 cm) from the floor, if you’re installing a 660
–
80 3/4" (205.1 cm) from the floor, if you’re installing a 680
If the room’s ceiling is lower than recommended (see the Important Note above), you must
measure down from the ceiling rather than up from the floor. This guarantees that there’s
enough clearance between the projector mount and the ceiling. Make sure the
highest
anchor
holes are at least:
–
4" (10.2 cm) from the ceiling, if you’re installing a 660
–
5" (12.7 cm) from the ceiling, if you’re installing a 680
2. Using an electric drill with a 1/2" bit, drill holes in the drywall at the six anchor hole locations
that you marked in the previous step.
3. Prepare a supplied toggle wall anchor by sliding one of the plastic ends back to make the
metal end lie flat.
4. Insert the toggle wall anchor into one of the drilled holes. The metal end straightens against
the inside of the drywall to create an anchor.
5. Slide the plastic cap into the hole, flush with the drywall, and bend the plastic handles up and
down to break them off.
IMPORTANT
If you’re installing the projector mount for a 660, the ceiling should be at least 8'4"
(2.54 m) high. If you’re installing the projector mount for a 680, the ceiling should
be at least 9'1" (2.76 m) high. If the ceiling doesn’t meet these requirements, the
interactive whiteboard’s pen tray will be below the recommended height. The
projector mount extends approximately 30" (76.2 cm) from the wall, and the room
need only be wide enough to accommodate the interactive whiteboard.
Plastic End
Metal End
Drywall
Plastic Cap
Summary of Contents for PMWT-660
Page 21: ......