2000i-DVX Installation Guide
17
Image Size Adjustment
To change the image size
1. Crouch behind the projector and look at the projected image through the view port.
Position for Changing the Image Size
2. Using the security key (TR20 Torx® tamper-resistant key) from the accessory kit, loosen the
three Torx M4 security screws that secure the projector to the projector plate.
NOTE:
You’ll find these screws on the top of the projector plate, one at the front of the projector
and two at the back.
Loosen the Three Hex Screws to Size the Image
To access the single screw at the front, you must reach through the view port to the front of the
projector, and maneuver the security key through the center access hole in the projector cover
(see the following figure).
3x
Summary of Contents for SMART Board 2000i-DVX
Page 1: ...Interactive Whiteboard Guide Installation ...
Page 8: ......
