6
Projector Replacement Guide for the 2000i
99-00496-00 REV A0
Aligning the Projected Image
If the projected image is blurry or does not fit the screen, complete the four adjustment procedures that
follow. For the first three, (roll, side-to-side and image size adjustment), you must watch the image on
the back of the screen while making the adjustments. You must also remove the view port cover
(attached with hook-and-loop fastener strips) at the rear of the unit to access the adjustment hardware.
To adjust image roll
1. Crouch behind the projector and look at the projected image through the view port.
2. While carefully observing the bottom edge of the image at the right side, use the 7/16" nut
driver to loosen or tighten the nut that’s located on the right side of the projector plate.
Roll Adjustment
Summary of Contents for SMART Board 2000i Projector replacement
Page 4: ......
