Appendix C
Mounting Your
Interactive
Whiteboard
on a Floor Stand
Before Mounting Your Interactive Whiteboard on a
Floor Stand
Before mounting your SMART Board V280 interactive whiteboard on an FSV280 floor
stand, carefully read and observe the following instructions for operating safety and to
avoid damage to your product.
WARNING
•
Two people are required to safely mount your interactive whiteboard on a
floor stand because it might be too large for one person to safely maneuver
alone. When you lift your interactive whiteboard, you and your assistant
should stand on either side of the screen, supporting its weight at the bottom
corners while balancing the top with your other hands.
•
Do not leave cables on the floor where they can be a tripping hazard. If you
must run a cable over the floor, lay it in a flat, straight line and secure it to the
floor with tape or a cable management strip of a contrasting color. Handle
cables carefully and avoid excessive bending.
•
Do not mount your SMART Board V280 interactive whiteboard on an FS670
or FS570 floor stand. These floor stands do not provide the correct locking
mechanisms to properly secure your interactive whiteboard. Using these
stands could result in personal injury and product damage.
•
Move a floor stand-mounted interactive whiteboard with care. Quick stops,
excessive force and uneven surfaces may cause your interactive whiteboard
to overturn.
Summary of Contents for SMART Board V280
