46
Using the Firmware
Welcome Center
The Welcome Center allows you to create or open Whiteboard files, Bridgit software conferences,
and computer and video source sessions, as well as open the
Unifi 35 Settings
dialog box to
configure the firmware (see page 9) and end the current session (see page 74).
The Welcome Center appears when you start a firmware session. If you’re in a Whiteboard file,
Bridgit software conference, or computer or video source session, open the Welcome Center by
pressing
Menu
in the toolbar.
Shortcut Menu
The shortcut menu allows you to move between Whiteboard files, Bridgit software conferences,
and computer and video source sessions without opening the Welcome Center.
NOTE:
A session only displays in the shortcut menu if you select its input’s
Add a button for this
input in the shortcut menu
check box (see page 18 and page 20).
To open the shortcut menu, press to the right of
Menu
in the toolbar. Press a session’s button to
move to that session, or press outside of the shortcut menu to close it.
The currently open
session is outlined
in yellow.
The
LinQ/Bridgit
dialog box only
displays if there are open
Bridgit software conferences or
LinQ software connections.