| 1016 Lunt Ave. Schaumburg, Illinois U.S.A. | Tel: 312.981.8774 |
14
R
LCD Monitor Connection (Optional)
The LCD Monitor enable live display of up to four cameras.
1.
Connect the 8-pin LCD monitor connector to the LCD monitor harness
2. Connect the 4pin female aviation connector to the video input cable on the LCD monitor
3. Connect the BNC female to the video out cable (BNC Male) on the CP4 harness
4. Make sure the CP4 video out/trigger harness is inserted into the “AV/OT Alarm Input” port on the
rear of the CP4
Remote Panic Button
The default display is Quad view (2x2) with all cameras shown, to change the video display channel,
press the [M2] button (see below) on the CP4 Remote Panic Button to select which camera to view.
Each press will change the camera on display with the last option being all camera views. Trigger
inputs are associated to live channel display. In other words, the backup camera is full screen, when
the vehicle is in reverse. Contact SmartWitness support for assistance with configuring device.
1
4
Video Input from DVR
(BNC Male to 4 pin
Aviator Female Connection)
2
3
M2 Button
M1 Button
Panic
Button
Blue
LED Record
Red
LED Warning
Green
LED Network
