| 1016 Lunt Ave. Schaumburg, Illinois U.S.A. | Tel: 312.981.8774 |
15
THIS IS VIDEO TELEMATICS
Completion & Power-up
After installation of the CP4 and accessories into the vehicle you can turn on the ignition and CP4
recorder will power on.
1.
There will be a sequence of red, blue & green LED lights on the Remote/Panic Button during the
boot-up process.
2. Once boot-up is complete:
•
The red light will turn off and there will be only a solid blue and green (only for connected
device) light on. This indicates proper operation and recording.
•
There is an error when the red light is blinking (see “LED Status” on page 17
Contact your
supplier or visit
3.
Login to
and complete the installation wizard to validate the installation
and generate the installation report.
G-Sensor Calibration
G-sensor calibration is needed after installing the CP4.
1.
Turn on the unit and wait until it starts recording.
2. Press and hold M1 button (located on the remote controller)
for more than 2 seconds.
3. You will hear a beep when you press M1, and then you will
hear another beep after 2 seconds. Upon the second beep,
you can release M1 button.
4. The calibration is completed within 2 seconds.
NOTE: You must first go through mandatory training with SmartWitness to access
.
One you complete the training (about a 30-minute webinar), you will be provided login credentials. To
schedule training, please complete the
smartwitness.com/become-installer.html.
M1 Button for G-Sensor Calibration
