2000i-DVS Installation Guide
11
Powering up the 2000i
1. If the projector is not on, press the main power switch.
NOTE:
The projector in the figure below is shown upside down, just as it’s intalled in the 2000i.
VID
EO
IN
R
AUDI
O
L/M
ON
O
AU
DIO OU
T
S-VI
DE
O
IN
R
AUDIO
PC CO
NTRO
L
AC
IN
RGB
OU
T
L/M
ON
O
RGB
IN
AUDIO
US
B(PC
)
Main Power Switch
Main Power Switch on Projector
2. At the front of the 2000i, press the power button on the computer.
3. Turn on the projector lamp by pressing the
Lamp On
button on the Control Panel (to the right of
the pen tray).
The LED indicator beside this button flashes quickly for 60 seconds, and then remains steadily
illuminated when the projector lamp has powered up.
Lamp ON
On LED
Lamp On Button on the Control Panel
When an image displays, adjust the computer power settings and the image alignment on the
interactive screen. Then install the SMART Board software CD, configure the COM port, and
perform a brief orientation procedure. To do this, complete the procedures on the pages that
follow.
NOTE:
You should leave the computer and the projector on at all times (so the projector is either
in use, with the lamp illuminated, or in standby mode). However, you can set the computer to
save power during periods of inactivity. The following section describes how to do this.
Adjusting the Computer’s Power Settings
For greater ease of use, you should keep the computer on all the time. However, to help preserve the
computer's hard drive(s), and the life of the projector lamp, you should also set the monitor (the
interactive screen) and hard drive(s) to automatically go into standby after a specified period of
inactivity. You can do this by configuring the Windows operating system Power Management Feature.
If you do keep the computer on all the time, reboot the computer occasionally to reload the operating
system.
Summary of Contents for 2000i-DVS
Page 1: ...Interactive Whiteboard Guide Installation ...
Page 8: ......
