24
ATCA-F125 (6873M Artwork) Installation and Use (6806800J94N)
Sicherheitshinweise
Sicherheitshinweise
Beschädigung des Systems
Die Gebäude-internen Schnittstellen ("intra-building ports" per GR-1089-CORE) der
Geräte oder Baugruppen sind nur für gebäudeinterne Verkabelung vorgesehen. Die
Schnittstellen sind als Typ 2 oder Typ 4 definiert (wie in GR-1089-Core beschrieben) und
erfordern eine Isolation zu Leitungen außerhalb des Gebäudes.
Die Gebäude-internen Schnittstellen dürfen keine elektrisch leitende Verbindung zu
Leitungen außerhalb des Gebäudes haben. Ein "Primary Protector" (wie in GR-1089-
CORE beschrieben) ist keine ausreichende Absicherung, um die Gebäude-internen
Schnittstellen mit Leitungen außerhalb des Gebäudes zu verbinden.Die intra-Gebäude
Port (s) des Gerätes oder einer Unterbaugruppe müssen abgeschirmte
innerGebäudeVerkabelung / Verdrahtung, die an beiden Enden geerdet ist zu verwenden.
Operation
Beschädigung des Blades
Hohe Luftfeuchtigkeit und Kondensat auf der Oberfläche des Blades können zu
Kurzschlüssen führen. Betreiben Sie das Blade nur innerhalb der angegebenen
Grenzwerte für die relative Luftfeuchtigkeit und Temperatur. Stellen Sie vor dem
Einschalten des Stroms sicher, dass sich auf dem Blade kein Kondensat befindet und
betreiben Sie das Blade nicht unter -5°C.
Überhitzung und Beschädigung des Blades
Betreiben Sie das Blade ohne Zwangsbelüftung, kann das Blade überhitzt und schließlich
beschädigt werden. Bevor Sie das Blade betreiben, müssen Sie sicher stellen, dass das
Shelf über eine Zwangskühlung verfügt.
Verletzungen oder Kurzschlüsse
Blade oder Stromversorgung Falls die ORing Dioden des Blades durchbrennen, kann das
Blade einen Kurzschluss zwischen den Eingangsleitungen A und B verursachen. In diesem
Fall ist Leitung A immer noch unter Spannung, auch wenn sie vom Versorgungskreislauf
getrennt ist (und umgekehrt). Prüfen Sie deshalb immer, ob die Leitung spannungsfrei ist,
bevor Sie Ihre Arbeit fortsetzen, um Schäden oder Verletzungen zu vermeiden.
Schaltereinstellungen
Fehlfunktion des Produktes
Schalter, die mit 'Reserved' gekennzeichnet sind, können mit produktionsrelevanten
Funktionen belegt sein. Das Ändern dieser Schalter kann im normalen Betrieb Störungen
auslösen.
Verstellen Sie nur solche Schalter, die nicht mit 'Reserved' gekennzeichnet sind.