44
ATCA-F125 (6873M Artwork) Installation and Use (6806800J94N)
Hardware Preparation and Installation
Hardware Preparation and Installation
5. Wait for the blue LED to glow. The blue LED glows when the AMC module is completely
engaged with the connector.
6.
Press module handle inwards towards the face plate to lock the AMC module on the
AMC bay.
7. Wait for the blue LED to perform a series of long blinks. The blue LED blinks when the
handle is locked in position indicating module detection and activation by the carrier
board.
8.
Observe blue LED status/activity. The module is fully installed when the blue LED stops
blinking and stays OFF.
Removal Procedure
This procedure assumes that the AdvancedATCA system is powered. If your system is
powered down, you can disregard the instructions regarding the blue LED.
1.
Remove any cables that are connected to the AMC module face plate connectors.
2.
Gently pull the module latch outwards, approximately 3 mm away from its locked
position.
3. Wait for the blue LED to perform short blinks, and then glow steadily.
4.
Once the blue LED glows steadily, gently pull the AMC module handles outwards to
disconnect the module from the AMC connectors. Continue to gently slide the module
outwards along the guide rails.
5.
Install the filler panel.
NOTICE
Data Loss
Removing the blade with the blue LED still blinking causes data loss.
Wait until the blue LED is steadily lit, before removing the blade.
