Setting up the computer 2 connection location
You can set up cabling that enables you to connect a second computer to your interactive flat
panel from another location in the room such as on a conference table. By setting up this
connection location, you make use of connection points that might not be accessible when your
interactive flat panel is wall-mounted.
You require a USB cable and a VGA cable to set up the computer 2 connection location.
W A R N I N G
Ensure that any cables extending across the floor to your SMART product are properly bundled
and marked to avoid a trip hazard.
g
To set up a computer 2 connection location
1. Connect a USB cable to the USB 2 receptacle on the inside terminal panel, and then run
the cable to the computer 2 connection location.
2. Connect a VGA video cable to the VGA 2 port on the bottom terminal panel, and then run
the VGA Out end of the cable to the remote connection location.
3. Bundle and cover the cables as appropriate.
C H A P T E R 2
Connecting computers and peripheral devices
14 | 1013787 Rev 03
Summary of Contents for 8055i
