l
Replace the lamp module and lamp cover (page 40)
l
Replace the projector (page 40)
You need a Phillips No. 2 screwdriver to perform the following procedures.
Removing the projector from the boom
Before you can access the projector lamp module, you must remove the projector from the boom.
W
W A R N I N G
Two people are required to remove the projector from the boom.
g
To remove the projector from the boom
1. Press the
Power
button twice on the remote control or ECP to put the system into Standby
mode.
2. Wait at least 30 minutes for the projector to cool down completely, and then disconnect the
power cable from the power outlet.
3. Remove the cable cover, and then disconnect all cables from the projector.
C H A P T E R 5
Maintaining your interactive whiteboard system
35
