8. Press the
Power
button once on the remote control or ECP to confirm that the projector is
operating and that the lamp module is correctly installed, and then wait for the projector to turn
on completely.
The ECP’s Power light turns solid green when the system starts.
9. Wait five minutes for the projector to warm up.
N
N O T E
You might need to adjust the projected image after you perform the previous procedures. For
more information, see the included
SMART Board 600i4 and D600i4 interactive whiteboard
system installation instructions
(
) and
Focusing and adjusting the projector image
For information on focusing and adjusting the projector image, see
and
Replacing the projector lamp
This section provides detailed instructions for replacing the projector lamp module.
Removing and replacing the projector lamp module
If the lamp fails, or if a replacement message appears on the projector screen, have a qualified person
replace the projector lamp module.
W
W A R N I N G
l
See
for the projector’s MSDS documents.
l
Replace the lamp module when the projector displays its lamp life warning message. If you
continue to use the projector after this message appears, the lamp can shatter or burst,
scattering glass throughout the projector.
C H A P T E R 5
Maintaining your interactive whiteboard system
43
