Appendix B:
Remotely managing your system
through an RS-232 serial
interface
Connecting your room control system to the ECP
Projector programming commands
Projector power state controls
Absolute values and adjustment values
Video source specification values
Additional VGA source controls
Additional Composite video source controls
This appendix includes detailed instructions on how to set up your computer or room control system
to remotely manage your SMART Board 600i4 interactive whiteboard system settings through an
RS-232 serial interface.
Connecting your room control system to the ECP
By connecting a computer or room control system to the 4-pin connector on the ECP, you can select
video inputs, start up or shut down your interactive whiteboard system and request information such
as projector lamp use, current settings and network addresses.
Appendix B
71
