These commands inform you of the current network settings.
Command
Response
get netstatus
netstatus=connected
netstatus=disconnected
netstatus=disabled
get dhcp
dhcp=[current DHCP status]
get ipaddr
ipaddr=[current IP address]
get subnetmask
subnetmask=[current subnet mask number]
get gateway
gateway=[current network gateway]
get primarydns
primarydns=[current primary domain server]
get macaddr
macaddr=[current MAC address]
These commands control your network settings.
Command
Command target range
Response
set dhcp [target]
=on
=off
dhcp=[current]
set ipaddr [target]
=0.0.0.0 to =255.255.255.255
ipaddr=[current]
set subnetmask [target]
=0.0.0.0 to =255.255.255.255
subnetmask=[current]
set gateway [target]
=0.0.0.0 to =255.255.255.255
gateway=[current]
set primarydns [target]
=0.0.0.0 to =255.255.255.255
primarydns=[current]
A P P E N D I X
B
Remotely managing your system through an RS-232 serial interface
80
