CHAPTER 5
USING YOUR INTERACTIVE FLAT PANEL
37
smarttech.com/kb/170446
2. Disconnect the USB cable from your laptop, and then connect it to the SMART GoWire cable’s
USB receptacle.
NOTE
If the SMART GoWire cable isn’t connected to your interactive flat panel through a USB
cable, you have access to SMART Meeting Pro PE software on your laptop for five minutes,
and then the software closes.
3. Connect the SMART GoWire cable’s USB connector to your laptop.
The
AutoPlay
dialog box appears.
4. Select Start SMART Meeting Pro PE.
SMART Meeting Pro PE software starts. You have touch control of your laptop on your
interactive flat panel and can use SMART Meeting Pro PE software while your laptop is
connected to your interactive flat panel.
To disconnect a SMART GoWire cable
1. If required, save your SMART Meeting Pro software file to your laptop. You can save the file as
an .fcw file.
NOTE
You can open an .fcw file on a computer that has SMART Meeting Pro software or
SMART Meeting Pro PE software or that is connected to a SMART product through a
SMART GoWire cable.
2. Close SMART Meeting Pro PE software.
3. Disconnect the SMART GoWire cable from your laptop and the USB cable.
Changing input sources
You can connect the interactive flat panel to a room computer, one or two guest laptops and other
devices (see
You can display a device’s input source by pressing the Input Select button
on the front
control panel until the device’s input appears on the interactive flat panel. Alternatively, you can
press the INPUT button on the remote control.
