High-voltage battery
Charging time
(from 10% to 80%)
at 8 A/230 V
Approx. 9 h
30 min
Vehicles with a 22 kW
on-board charger
Charging time
(from 10% to 80%)
at 3x32 A/230 V
Approx. 40 min
Charging cable
Charging the battery at a charging station
or wall box
Nominal voltage
max. 400 V AC,
max. 3-phase
Nominal frequency
50 Hz/60 Hz
Nominal current
max. 32 A
Charge output
from 4.6 kW to
22 kW
System of protection
IP44 (inserted),
IP24 (not
inserted)
Outside temperature
Observe the notes on
maintaining the high-
voltage bat-
-40
†
to +50
†
Standards
IEC 61851-1,
IEC 62196-1,
IEC 62186-2
Interface
Type 2 to Type
2
Also observe the identification plate on the
charging cable connector.
Service products
Please note
Also observe the information in the section
"Checking and refilling service products"
Vehicle components and their respective
service products must match. Therefore,
only use products tested and approved by
Mercedes-Benz.
Information on service products
The following table lists all technical data
for the service products of the vehicle. Fur-
ther information on service products:
http://bevo.mercedes-benz.com
and in any
smart Centre.
Service prod-
ucts
Specifications
Corrosion
inhibitor/
antifreeze
325.6, 326.6
MB-Freigabe or MB-
Approval is stated on the
corrosion inhibitor/anti-
freeze containers.
Windscreen
washer fluid
Temperatures above
freezing point: mixing
ratio of 1:100
MB SummerFit to water.
Temperatures below
freezing point: for the
correct mixing ratio of
MB WinterFit and water,
please observe the infor-
mation on the antifreeze
container.
Bulb types
The following table lists the correct bulb
types of the vehicle:
Bulb
Type
Dipped-beam/main-beam
headlamps
H4 60/55
W
Front foglamps
H 16
Turn signals
PY 21 W
Side turn signal lamps
WY 5 W
Licence plate lighting
W 5 W
Interior lighting
W 5 W
Bulb types
215
>> Technical data
.
