Información México
La operación de este equipo está sujeta a las siguientes dos condiciones:
1 ) es posible que este equipo o dispositivo no cause interferencia perjudicial y
2) este equipo debe aceptar cualquier interferencia, incluyendo la que pueda causar su operación no deseada.
Este equipo ha sido diseñado para operar con las antenas
que enseguida se enlistan y para una ganancia máxima de
antena de 2.18 dBi para 2.4 GHz/3.02 dBi para 5.8 GHz. El
uso con este equipo de antenas no incluidas en esta lista o
que tengan una ganancia mayor que 2.18 dBi para 2.4 GHz/
3.02 dBi para 5.8 GHz quedan prohibidas La impedancia
requerida de la antena es de 50 ohms.
Tipo de Antena Marca
Modelo
Ganancia (dBi)
Dipole
PSA
RFDPA870900SBLB8G1 2400-2483.5GHz: 2.18 dBi
5725-5825GHz: 3.02 dBi
Federal Communication Commission interference statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate this equipment.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and
operated with minimum distance of 20cm between the antenna and all persons.
NOTE:
This product has been configured to operate according to the FCC rules in the US.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 5.15–5.25 GHz frequency band
operation is restricted to indoor use only. Outdoor operations in the 5150~5250 MHz are prohibited.
Industry Canada statement:
This device complies with RSS-210 of the Industry Canada
Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Caution:
(i) the device for operation in the band 5150-5250 MHz is
only for indoor use to reduce the potential for harmful
interference to co-channel mobile satellite systems;
(ii) the maximum antenna gain permitted for devices in
the bands 5250-5350 MHz and 5470-5725 MHz shall
comply with the e.i.r.p. limit; and
(iii) the maximum antenna gain permitted for devices in
the band 5725-5825 MHz shall comply with the e.i.r.p.
limits specified for point-to-point and non point-to-
point operation as appropriate.
(iv) Users should also be advised that high-power radars
are allocated as primary users (i.e. priority users) of the
bands 5250-5350 MHz and 5650-5850 MHz and that
these radars could cause interference and/or damage
to LE-LAN devices.
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits
set forth for an uncontrolled environment. This equipment
should be installed and operated with a minimum distance
of 20 cm between the antenna and all persons.
Ce dispositif est conforme à la norme CNR-210 d’Industrie Canada applicable
aux appareils radio exempts de licence. Son fonctionnement est sujet aux
deux conditions suivantes: (1) le dispositif ne doit pas produire de brouillage
préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un
brouillage susceptible de provoquer un fonctionnement indésirable.
Avertissement:
Le guide d’utilisation des dispositifs pour réseaux locaux doit inclure des
instructions précises sur les restrictions susmentionnées, notamment :
(i) les dispositifs fonctionnant dans la bande 5 150-5 250 MHz sont réservés
uniquement pour une utilisation à l’intérieur afin de réduire les risques de
brouillage préjudiciable aux systèmes de satellites mobiles utilisant les
mêmes canaux;
(ii) le gain maximal d’antenne permis pour les dispositifs utilisant les bandes
5 250-5 350 MHz et 5 470-5 725 MHz doit se conformer à la limite de p.i.r.e.;
(iii) le gain maximal d’antenne permis (pour les dispositifs utilisant la bande
5 725-5 825 MHz) doit se conformer à la limite de p.i.r.e. spécifiée pour
l’exploitation point à point et non point à point, selon le cas.
(iv) De plus, les utilisateurs devraient aussi être avisés que les utilisateurs de
radars de haute puissance sont désignés utilisateurs principaux (c.-à-d.,
qu’ils ont la priorité) pour les bandes 5 250-5 350 MHz et 5 650-5 850 MHz
et que ces radars pourraient causer du brouillage et/ou des dommages aux
dispositifs LAN-EL.
Déclaration d’exposition aux radiations:
Cet équipement est conforme aux limites d’exposition aux rayonnements
IC établies pour un environnement non contrôlé. Cet équipement doit être
installé et utilisé avec un minimum de 20 cm de distance entre la source de
rayonnement et votre corps.
1028554 Rev 03
support.smarttech.com
support.smarttech.com/contact-support
© 2017 SMART Technologies ULC. All rights reserved. SMART Board, SMART MeetingPro, SMART Notebook, smarttech, the
SMART logo and all SMART taglines are trademarks or registered trademarks of SMART Technologies ULC in the U.S. and/
or other countries. All third-party products and company names may be trademarks of their respective owners. Contents are
subject to change without notice. This product and/or use thereof covered by one or more of the following U.S. patents:
smarttech.com/patents. Other patents pending. 03/2017
*1028554*
Hardware environmental compliance
SMART Technologies supports global efforts to ensure that electronic equipment is manufactured, sold and disposed of in a safe
and environmentally friendly manner.
Waste Electrical and Electronic Equipment and
Battery regulations (WEEE and Battery Directives)
Electrical and electronic equipment contain substances
that can be harmful to the environment and to human
health. The crossed-out wheeled bin symbol indicates
that products should be disposed of in the appropriate
recycling stream and not as regular waste.
See smarttech.com/compliance for more information.
Batteries
The kapp iQ AM30 contains a CR2032 coin cell battery. Recycle
or dispose of batteries properly.
Perchlorate material
Battery contains perchlorate material. Special handling may apply.
dtsc.ca.gov/hazardouswaste/perchlorate
(Hazardous Materials Table)
smarttech.com/compliance
In accordance with the provisions of SJ/T 11364, please visit smarttech.com/compliance for this product hazardous materials table.
+
-
