6
|
CHAPTER 2
– INSTALLING THE INTERACTIVE PEN DISPLAY
99-00724-00 D0
To connect a projector or
monitor to the interactive
pen display
1. Connect a VGA (RGB) video cable (not supplied) to the
RGB Video OUT
receptacle on the interactive pen display.
2. Connect the other end of the cable to the
Video Input
receptacle on your
projector or monitor.
For details about the projector’s connectors, see the instructions that came
with your projector.
Attaching the Pen
Use the tether to attach the pen to the interactive pen display, so the pen is always
within reach.
NOTE
When you’re not using the pen, put it in the storage compartment that’s
located on the top of the unit.
To attach the tether to the
pen and an ID350
interactive pen display
1. There is a loop in the cord at each end of the tether. Thread one loop through
the opening at the end of the pen, and then slip the rest of the cord through
the loop. Carefully pull the cord until the loop is snug.
2. Thread the other loop through the installation fitting. Then slip the pen and the
rest of the tether through the loop. Carefully pull the pen until the loop is snug.
NOTES
You can attach the installation fitting to any of the four available holes on the
back of the interactive pen display. Two of these holes are on the left side (if
you view the interactive pen display from the back). The other two holes are
close to the connection panel on the right side (if you view the interactive pen
display from the back).
Installation
Fitting
Tether
Pen
Summary of Contents for Podium ID350
