Setting
Use
Notes
Contact
Displays the contact name or number
for projector support as set by an
administrator (maximum 16
characters).
You can set the contact name or
number using the remote management
features (see
system through a network interface
page 59 and
system through an RS-232 serial
interface
Language menu
Language
Selects language preference.
Projector menu support is available in
English (default), Chinese (Simplified),
Chinese (Traditional), Czech, Danish,
Dutch, Finnish, French, German,
Greek, Italian, Japanese, Korean,
Norwegian, Polish, Portuguese
(Brazil), Portuguese (Portugal),
Russian, Spanish and Swedish.
Information menu
Lamp Hours
Displays the current number of lamp
usage hours from 0 to 4000 hours from
when it was last reset.
Always reset the lamp hours after you
replace a lamp, because lamp service
reminders are based on the current
hours of use. See
on page 41 for details on the
lamp hours reset procedure.
Input
Displays the currently displayed video
input source (
VGA-1
,
VGA-2
,
Composite
,
S-Video
,
HDMI
or
None
).
Resolution
Displays the projector’s most recently
detected video source signal resolution
and refresh rate.
If there is no current video input source
signal, this setting displays the last
known source signal image resolution
and refresh rate.
Firmware Version
Displays the projector’s digital display
processor (DDP) firmware version in
x.x.x.x format.
MPU Version
Displays the projector microprocessor
unit (MPU) firmware version in x.x.x.x
format.
Network Version
Displays the projector’s network
communications processor firmware
version in x.x.x.x format.
If you haven’t enabled the
Network
and VGA Out
setting, this setting is
unable to display the projector’s
network communications processor
firmware version and displays 0.0.0.0
instead.
Model Number
Displays the projector’s model number.
Serial Number
Displays the projector’s serial number.
C H A P T E R 3
Using your interactive whiteboard system
20
