Command
Response
get blue
blue=[current blue color setting]
get cyan
cyan=[current cyan color setting]
get magenta
magenta=[current magenta color setting]
get yellow
yellow=[current yellow color setting]
get videofreeze
videofreeze=[current video freeze setting]
get cc
cc=[current closed captioning language setting]
These commands control the appearance of your source. These settings are unavailable when the
projector is in Standby mode or when the source is disconnected. See
on page 70 for setting absolute and adjustment commands.
Command
Command target range
Response
set displaymode [target]
=SMARTpresentation
=brightroom
=darkroom
=sRGB
=User
displaymode=[target]
set brightness [value]
=0 to =100
brightness=[value]
set contrast [value]
=0 to =100
contrast=[value]
set whitepeaking [value]
=0 to =10
whitepeaking=[value]
set degamma [value]
=0 to =3
degamma=[value]
set red [value]
=0 to =100
red=[value]
set green [value]
=0 to =100
green=[value]
set blue [value]
=0 to =100
blue=[value]
set cyan [value]
=0 to =100
cyan=[value]
set magenta [value]
=0 to =100
magenta=[value]
set yellow [value]
=0 to =100
yellow=[value]
set videofreeze [target]
=on
=off
videofreeze=[target]
set cc [target]
=cc1
=cc2
=off
cc=[target]
N
N O T E
Typically,
cc1
displays English (U.S.) subtitles, while
cc2
displays other regional languages, such
as French or Spanish, depending on television channel or media setup.
A P P E N D I X
B
Remotely managing your system through an RS-232 serial interface
73
