These commands inform you of the current system settings. These commands are available even
when the projector is in Standby mode.
Command
Response
get lamphrs
lamphrs=[current lamp hours of operation]
get syshrs
syshrs=[current projector hours of operation]
get fwverddp
fwverddp=[current projector firmware version]
get fwvernet
fwvernet=[current network firmware version]
get fwvermpu
fwvermpu=[current processor firmware version]
get fwverecp
fwverecp=[current ECP firmware version]
get vgaoutnetenable
vgaoutnetenable=[current]
get signaldetected
signaldetected=[true or false]
get usb1source
usb1source=[Video source associated with the USB 1 connector on
the ECP]
get usb2source
usb2source=[Video source associated with the USB 2 connector on
the ECP]
T
T I P
The
get usb1source
and
get usb2source
commands are only applicable to SMART UX60
projectors running DLP firmware version 1.0.0.4 or later.
These commands control the current system settings. These commands are unavailable when the
projector is in Standby mode. See
on page 70 for setting absolute
and adjustment commands.
Command
Command target range
Response
set autosignal [target]
=on
=off
autosignal=[target]
set lampreminder [target]
=on
=off
lampreminder=[target]
set highbrightness [target]
=on
=off
highbrightness=[target]
set autopoweroff [value]
=0 to =240
autopoweroff=[value]
set zoom [value]
=0 to =30
zoom=[value]
set projectorid [value]
=0 to =99
projectorid=[value]
set hposition [value]
=0 to =100
hposition=[value]
set vposition [value]
=-5 to =5
vposition=[value]
set aspectratio [target]
=fill
=match
=16:9
aspectratio=[target]
A P P E N D I X
B
Remotely managing your system through an RS-232 serial interface
78
