Submenu setting
Description
DNS
Displays or allows you to set the projector’s IP address for your
network’s primary domain name server in values between 0.0.0.0 and
255.255.255.255.
Group Name
Displays or allows you to set the projector’s workgroup name
(maximum 12 characters).
Projector Name
Displays or allows you to set the projector’s name (maximum 12
characters).
Location
Displays or allows you to set the projector’s location (maximum 16
characters).
Contact
Displays or allows you to set the contact name or number for projector
support (maximum 16 characters).
SNMP Enable
Turns the Simple Network Management Protocol (SNMP) agent on or
off.
Read-Only Community
Sets a password that is required for each SNMP get request to
the device.
N
N O T E
The default for Read-Only Community is public.
Read/Write Community
Sets a password that is required for each SNMP set request to the
device.
N
N O T E
The default for Read/Write Community is private.
Trap Destination Address
Displays or allows you to set the IP address of the network’s SNMP
TRAP manager in values between 0.0.0.0 and 255.255.255.255. The
trap destination address is the IP address of the computer assigned to
handle unsolicited data generated by SNMP TRAP events generated
by the projector, such as power state changes, projector failure
modes, a lamp needing to be replaced or other issues.
A P P E N D I X
A
Remotely managing your system through a network interface
64
