CHAPTER 2
USING THE DISPLAY
18
The Standby button also functions as an indicator light:
Indicator light
Status
Procedure
Solid white
Normal operation
[N/A]
Off
Not receiving power
l
Confirm the display’s power cable is
connected to the power outlet.
l
Flick the switch beside the AC power inlet
to the ON (I) position.
Solid amber
DPMS (power
management) mode
l
Press the
Standby
button
to exit
DPMS mode.
l
Connect an input source.
Slowly flashing
amber
Standby mode
l
Press the
Standby
button
to exit
Standby mode.
l
If presence detection is enabled, move in
range of the presence detection sensor.
l
If Wake to Touch is enabled, touch the
screen.
Flashing amber
No USB connection from
the connected computer
l
Verify the connections to the computer.
l
Switch to the computer’s input.
See
Viewing a connected computer’s
Slowly flashing
white
SMART Board service not
running on the connected
computer
Ensure that SMART Product Drivers is
installed and that the SMART Board
service is running.
Adjusting audio
If you’re presenting content with sound, you can use the buttons on the front control panel to
increase, decrease, mute and unmute the volume (see
Freezing the screen
You can temporarily freeze the screen by pressing and holding the
Mute
button on the front
control panel (see
on page 8). This is particularly useful when you want to
pause a video, an animation or other moving content.
NOTE
Freezing the screen does not pause any applications running on the connected computer. It
simply freezes the display of those applications.
To unfreeze the screen, press and hold the
Mute
button again.
Summary of Contents for SPNL-6065
Page 8: ......
Page 36: ......
Page 45: ......
Page 46: ...SMART TECHNOLOGIES smarttech com support smarttech com contactsupport smarttech com kb 171166...