33 English
User Controls
User Controls
Control Panel
Auto Signal Detect
Auto Signal Detect enables the sequential searching of input
connectors for an signal.
On
scans the inputs sequentially until the first input signal is
found.
Off
keeps the signal detection in one input connector.
Lamp Reminder
Select this option to show or to hide the warning message when
the “change lamp” message displays. The message appears 00
hours before the recommended lamp replacement.
Lamp Mode
To adjust the brightness of the image:
Select
Standard
to lighten the image.
Select
Economy
to darken the image.
Auto Power Off
Set the countdown timer interval. The countdown timer starts when
there is no signal being sent to the projector. The projector enters
Idle Mode when the countdown finishes.
If user wishes to re-start the projector, please power on the
projector again.
Zoom
Adjust the image on the projection screen.
Summary of Contents for UF55
Page 57: ......