9 English
User Controls
User Controls
Auto Signal Detect
Auto Signal Detect enables the sequential searching of input
connectors for a signal.
On
scans the inputs sequentially until the first input signal is
found.
Off
keeps the signal detection in one input connector.
Lamp Reminder
Select this option to show or to hide the warning message when the
“change lamp” message displays. The message appears 00 hours
before the recommended lamp replacement.
Lamp Mode
To adjust the brightness of the image:
Select
Standard
to brighten the image.
Select
Economy
to darken the image.
Auto Power Off (minutes)
Set the countdown timer interval. The countdown timer starts when
there is no signal being sent to the projector. The projector enters
Idle Mode when the countdown finishes.
If user wishes to re-start the projector, please power on the
projector again.
Default
Settings
Summary of Contents for UF55
Page 57: ......
