Section 3 Programming Passcode
3.1
Passcode information
Battery failure
No LED or beeps.The display
keypad is invalid.
Replace batteries immediately.The
mechanical keys supplied can be
used to unlock the door. Alternative-
ly inset a 9V back up battery as
shown to activate the display
keypad.
Condition
Indicator
Solution
Batteries low
• The default passcode is 123456. Once you add a new passcode, the default one
would become invalid.
• Maximum 8 sets of passcode can be set for family use.
The Passcode can be any combination of 6~8 digits.
How to use the keypad!
There are 5 touch keys on the keypad as shown
on the right. To input a digit, press the circle
where the number lies.
Back-up Battery Socket
11
9V
_
+
Battery Icon on the display keypad
outside will light up to indicate low
battery . Meanwhile, the PIN
GENIE button on the back will flash
red for about 1 minute at the same
time.
Replace batteries immediately to
avoid battery failure. Smart lock can
still be operated for approximately
300 cycles in low battery condition.