SG361 GSM/GPRS Module
SG361 GSM/GPRS Module Version 1.0 2014-02-23 Page 7 of 8
3 TYPICAL APPLICATION AND INSTALLATION STEPS
3.1 TYPICAL APPLICATION
3.2 INSTALLATION STEPS
1 INSERT SIM CARD
The drawer of the SIM card will pop up after the yellow key is pressed using needle.
Insert the SIM card into the slot and then close the drawer.
2 INSTALL ANTENNA
Connect the antenna to SMA interface and then tighten the screws.
3 COMMUNICATE WITH CONTROLLER
Details connection way pleases refer to
Chapter 3.1
TYPICAL APPLICATION
4 CONNECT POWER LINE
The power should not less than 5W to ensure the operation is smoothly as the
power supply voltage of the SG361 module is DC(8~32)V. The system is normal
running if the network status indicator is
“64ms On/300ms Off” and users can
control data transmission via AT command.