35
ENGLI
SH
Manually transfer Not Sent data
You can also manually trigger data transfer to the receiving device. To do so, you first
have to turn on SEND mode on your
smartLAB
®
walk
P+
device.
Please quickly press and release the “Disp/ Set” button, and then press it again for 6
seconds. In the upper display area “SEnd” appears.
If you now press „M/
” the display will show “picture 7”.
By pressing “Disp/ Set” again, you will manually trigger the data, which has not been
sent yet, transfer. The symbol for wireless data transfer
will flash in the display.
If the data transfer was successful, you will see “picture 9”; if the data transfer could
not be completed, “picture 10” will appear on display. In case no connection at all
can be established, the display will show “picture 11”.
pict. 7
