SwitchLinc V2 Relay User’s Guide
3.
Cap the other TRAVELER wire.
The other TRAVELER wire, usually red, will not be used, so put a
wire nut on the end of it.
4.
Cap the red LOAD wire from the SwitchLinc Secondary.
Put a wire nut on the end of the SwitchLinc Secondary’s
LOAD wire to ensure that it won’t connect to anything.
5.
Connect the SwitchLinc Secondary’s NEUTRAL Wire.
Locate the group of NEUTRAL wires, usually white, in the
rear of the box. The old switch should not have been
connected to the NEUTRAL wires, but SwitchLinc Relay
requires this connection in order to draw a small amount of
power for itself. Connect SwitchLinc Secondary’s white
NEUTRAL wire to the other NEUTRAL wires with a wire nut.
Page 11 of 32
