SwitchLinc V2 Relay User’s Guide
Unlinking SwitchLinc Relay from an INSTEON Controller
If you are no longer going to control a SwitchLinc Relay with an INSTEON Controller, it is very important
that you unlink it, because otherwise the controller will retry any commands intended for the unused
SwitchLinc Relay, thus slowing down your system.
1. Select your INSTEON Controller from the list below and follow the method shown to put it into
Unlinking Mode
.
A.
A Second SwitchLinc V2 Relay
– Follow the instructions in the section
Unlinking a Controlled INSTEON Device from SwitchLinc Relay
, above.
(Briefly, press and hold the Second SwitchLinc Relay’s
Paddle Top
for 10
seconds
twice
.)
B.
ControLinc
™
V2 Tabletop Controller
– Press and hold the
OFF Button
of
the ON/OFF Button Pair you used for controlling SwitchLinc Relay for 10
seconds. To confirm that it is in Unlinking Mode, ControLinc V2’s Status LED
will begin blinking.
C.
KeypadLinc
™
V2
– Press and hold for 10 seconds the
ON Button
you used
for controlling SwitchLinc Relay, then press and hold the same
ON Button
for
10 seconds
again
. To confirm that it is in Unlinking Mode, KeypadLinc V2 will
flash the light that it is wired to once and begin blinking the ON Button that you
pushed.
D.
Other INSTEON Controllers
– See the INSTEON Controller’s User’s Guide.
2. Press and hold the
Paddle Top
for 10 seconds on the SwitchLinc Relay that
is being controlled. To confirm unlinking, the SwitchLinc Relay will blink the
top LED in its LED Bar and also the light that it is wired to. Depending on
the INSTEON Controller, you have about 4 minutes to perform this step
before Unlinking Mode times out automatically.
Page 17 of 32
