Remove the HDD cover by pressing 2
locks at the same time.
Take 2 screws and a handle from the HDD
connection kit. Fix screws as it is shown in
the picture.
Place the hard disk into the compartment.
Plug in the disk to the slot using the
handle as it is shown in the picture.
19
Switch off the device and disconnect it from the wall outlet. Turn
the device upside-down. To prevent scratching the glance sur-
faces, put it on a fabric laying.
Attention!
To install 12 mm disk, carefully cut off the lug at the internal side of
the HDD cover. A plastic handle is not required in this case.
