5 YEAR
MOTOR WARRANTY
PREMIUM REMOTES POWERED BY SW SUN CONTROL
SMART LINE REMOTE
SMART LINE
Remotes
5 Channel
TECHNICAL DATA
Power Supply
3V Lithium Battery (CR2023)
Battery Life
2 Year
Frequency
434.15 MHz
Remote Range (feet)
65
Remotes enable the user to control one or more motors, installed on awnings and screens. It is possible to set them up in order
to create group commands and let more motors work simultaneously.
The radio signal is shown by the transmission LED. If the LED doesn’t blink after the button pressure, then the battery has to be
replaced.
PLEASE NOTE:
Do not use motors with remote controls in areas with risks of radio disturbs over the norm (i.e. airports
or radio repeaters). These units may also be disturbed by telecommunication and/or transceiver systems with the same
frequency.
PROGRAMMING Remote
CAUTION: If multiple motors have to
be installed, it is important to power
on one motor at time during the first
programming session, in order to avoid
any interferences with the motors.
1. Power on the motor to be paired/
programmed.
2. Press and hold
TX
until the motor
starts moving.
3. Check the rotation of the motor,
then release
TX
(the motor stops).
4. Within 5 seconds press the
corresponding button (i.e.
UP
if the
motor rotated up or
DOWN
if vice
versa).
The remote is now programmed
and the rotation of the motor is now
synchronized.
2.
3.
4.
PROGRAMMING REMOTES
Programming remotes and setting the
limits are made through the buttons
shown below.
TX
FC
BACK
FRONT
INSIDE
TX
FC
Battery
Protective Cover-
DO NOT REMOVE
TX
|
FC
UP
shade/awning up
STOP
shade/awning stops
DOWN
shade/awning down
PRESET
intermediate position
ALL
selects all channels
1, 2, 3, 4, 5
select channel
TX
program remote
FC
set limits
ADDING Remote
2. Press and hold
TX
of a programmed
remote until the motor starts
moving.
3. Check the rotation of the motor,
then release
TX
(the motor stops).
4. Within 5 seconds, on the new
remote, press the corresponding
button
(i.e.
UP
if the motor rotates
upwards or
DOWN
if vice versa).
Additional remote is now added.
CHECKING/CHANGING DIRECTION
IMPORTANT: change direction must
be performed before starting limit
setting otherwise limits must be
reset.
1. Press
UP
or
DOWN
: The motor will
go up or down, otherwise to change
direction.
2. Press and hold
TX
button until the
motor starts moving.
3. Press
STOP
: The motor makes a
brief jog.
Direction of motor has been reversed.
2.
3.
1.
BRIEF JOG
LONG JOG
Change direction of buttons
Delete a single remote
Erase memory
Set limit positions
End programming mode
Set intermediate position
Erase intermediate
position
1255
STOP
UP
DOWN
