Operating Manual
OM_Axessor_CIT_V024_20170518_EN.pdf
Subject to change without prior notice
Page 39
Axessor CIT
5.7.10
The close seal is displayed (mode I)
After the Axessor CIT has been locked or the time
window for entry of the combination has elapsed, the 6
digit close seal will appear in the display. This close seal
must be forwarded to the dispatch centre after the lock
has been closed.
5.7.11
Post-access delay (modes S and I)
The lock is currently waiting for the post-access time
delay to expire and can not be opened. The
<INFO/ESC>
key can be used to call up the battery status and the
last-used lock seal.
5.7.12
Opening time delay (mode I)
In interactive mode, the waiting period is not displayed
during an opening time delay (unlike the indication given
in standard mode, see below).
5.7.13
Opening time delay (mode S)
After entering a valid code to open the lock the set Time
Delay starts counting – the remaining time is displayed.
A „BEEP signal“ is emitted every 60 seconds. Once the
counter has elapsed, the end of the Time Delay is indi-
cated with another „BEEP signal“.
Notes!
• The duration of a Time Delay may vary between the code groups.
• The Time Delay may be set to „count down“, „count up“ or „no count (00:00)“
• If the <DEL> key is pressed, the Time Delay is reset and the lock automati-
cally returns to „LOCKED“ status.
• The Courier Code overrides a Time Delay if not defi ned differently.
• An input may be defi ned to skip time delay.
Summary of Contents for Axessor CIT
Page 1: ......
