Operating Manual
OM_Axessor_CIT_V024_20170518_EN.pdf
Subject to change without prior notice
Page 95
Axessor CIT
AS284-USBW or AS284-NETW Programming Software
• Code combinations to open the lock can be set to: „Two Codes of same group“,
„Two Codes of different groups“ or „Any two codes“.
• Master Code can be defi ned as „cannot open“. If so, the Master Code can
neither be used to open the lock nor to start the Time Delay. The message
„DENIED“ is shown instead. However, if only one operable code is programmed
in Dual Mode, Master Code can open, though!
6.4.5.13 Enabling/disabling One Shot Codes - Submenu ONE SC4
bank
This setting defines, if the codes of the group 4 are used as one shot codes.
If defined as such, the codes defined can be used only once. After the us-
age, the code will not be valid for opening another time.
Authorization: Master Code
1. Select submenu „
ONE SC4 bank
“.
2. Press
the
<ENTER>
key. It is displayed if the One Shot codes are ena-
bled („on“) or disabled („off“).
3. Select either „
ON
“ or „
OFF
“ by toggling with the
<LEFT>
or
<RIGHT>
key, then press the
<ENTER>
key to confirm.
4. In the upcoming dialogue select „
YES
“ using the
<LEFT>
or
<RIGHT>
key, then press the
<ENTER>
key to confirm.
Summary of Contents for Axessor CIT
Page 1: ......
