Basic information about the device
30
Figure 25: individual parts of the object holder
1.
Removable object holder
for non-articulated jaw models. The model is fastened on the object
holder using a clamp. This clamp is fastened or released using the hex key (5).
2.
Three additional spacer plates
for height alignment.
3.
The locking plate
is screwed onto the spacer plates. The locking plate must always be the last
plate to be screwed to the spacer plates. A recess has been cut into one side of
the spacer
plates
and of the
locking plate
so that the plates can be assembled correctly. The locking
plate is fitted with a magnet, and acts as the connection piece with the object holder. There is
also a lock on the plate for the fixator available in the optional accessories.
4.
Calibration block
for axis and 3D calibration.
5.
Hex key
for clamping or loosening the plaster model on the model holder or the fastening
screws. Use the fastening screws to attach the locking plate to the spacer plates located
underneath on the system base plate firmly attached in the scanner.
11.3 Object holder
Individual parts of the object holder
The scope of delivery for the object holder of the
Activity 885
consists of the following components:
1
2
3
4
5
