54
Symbols
This function is necessary for technical support.
A log file is written that logs all settings and procedures and issues a detailed error message if
problems occur.
If sporadic "data holes" appear after a scan, you can close these
using the “Fill holes" function. The size of the hole to be closed is limited upwards by entering
the area in mm
2
. We recommend that you use this function for flat surfaces only. Incomplete
areas at preparation limits or sharp, occlusal edges should not be extended by this, as the area
to be replaced is only interpolated.
Fill large holes
If you activate the checkbox, the object will be displayed in the 3D viewer at an even higher
resolution. The object calculation when adding new records as well as during movements
requires much greater capacity from the graphics card and can lead to time delays.
Show measurements at the highest resolution
You can use this function to define whether matching is to be made to the existing STL or to
the existing individual images. The query is only set for an existing STL.
Prompt for matching on raw scan data
Existing individual images are again used to create STLs also for re-scans and additional scans
and an already existing STL is not used for the calculation as a matter of principle.
Always match scan data
The existing individual images are automatically deleted irrevocably when the program closes.
Automatically change to re-scan after each individual tooth presentation
The re-scan mode is started after each individual tooth presentation when this function is
activated. This function should only be used in complex cases.
Always delete scan data on program exit
Here you can choose whether the STL file of the individual image is to be cropped first. We
recommend cropping the STLs first.
Enable cropping of data to unmatched scans (PCM)
