12
SmartSolar™
Installation Instructions & Owners’ Manual
WARNING:
Do not connect the batteries until
Step D5 is completed.
Step D4 - Mount the Charger Board
Unplug the drive unit from mains power.
Disengage motor using manual release cord.
Remove the main cover, timing cover and light
diffuser, then remove the transformer, EMC board
and mains power cable.
Fix the Charger Board under the timing cover using
four (4) M4x8 screws (Fig. 17).
Feed the four wire cable through the opening, then
connect the three wire harness (red/yellow/black)
into the control board’s “SBY-3” connector (Fig. 18).
Plug the one wire harness (white) into the control
board’s “24vac in” connector on (Fig. 18).
Plug the solar shunt (supplied) onto the control
board’s “J13” connector (Fig. 18)
IMPORTANT WARNING:
Do not connect battery
or solar panel polarity incorrectly - this will result
in serious damage to components.
Step D5 - Connect the Solar Panel
Feed the Solar Panel’s cable through black grommet
on the chassis.
Connect the
red wire
to the Charger Board’s
“
SOLAR+
” connector, and the
black wire
to the
“
–SOLAR
” connector (Fig. 19).
WARNING:
During Step D6 the opener will
become active.
Step D6 - Mount & Connect the Battery
Mount the Battery Box close to the opener.
Feed the 2-core 18awg gauge cable (supplied)
through the Battery Box’s grommet.
Connect the
red wire
to the Battery Box’s “
+
”
terminal, and the
black wire
to the “
–
” terminal
(Fig. 20).
Feed the other end of the battery cable through the
drive unit’s black grommet.
Connect the
red wire
to the Charger Board’s
“
BAT+
” connector, and the
black wire
to the “
–
BAT
” connector (Fig. 19).
Refi t the timing cover, main cover and light diffuser.
Step D7 - Re-setup and Test the Opener
Setup travel limits and code transmitters as per the
GDO-6 instruction manual.
Press either the “OSC” buttons, or use a transmitter
to operate the opener.
1.
2.
3.
4.
5.
6.
7.
1.
2.
1.
2.
3.
4.
5.
6.
1.
2.
Roll Up Door Opener Set Up
GDO-6 EasyRoller
®
17
Fig
19
Fig
Re
d Wi
re
Black
Wire
20
Fig
18
Fig
B
la
ck
F
ro
m
R
e
d
F
ro
m
To
control
Board
JP1 Solar
Shunt
