4
• Hold the bottom lid as shown in Fig 4 and pull the tab marked
“PULL TO REMOVE BAG”
FIGURE 4
• Turn the filter bag inside out and hose off all debris as shown in Fig 5. If very dirty it may be washed in
your washing machine, inside out, with cold water, mild detergent, and by itself.
Do not put in dryer.
FIGURE 5
• Hose all debris off the bottom lid being sure to get all dirt out of the fine filters on the intake doors
as shown in Fig 6.
FIGURE 6
• To reattach the filter to the bottom lid, turn the filter bag right-side-out. Start at the back where the
filter bag says
“Warning: Push bag behind bottom lid TAB”
and insert the filter frame into the
channel, so that the tabs are holding the bag in near the label with the word
“Warning: Push bag
behind bottom lid TAB”
, as shown in Fig 7.
FIGURE 7
FIGURE 7A
FIGURE 7B
CORRECT INSTALLATION
INCORRECT INSTALLATION
• Press the filter frame down all the way around the perimeter making sure that it is
completely seated and behind all the tabs as shown in Fig 8.
FIGURE 8
FIGURE 11
• Pick up the bottom lid and turn it over so the bag hangs below it. Place the bottom lid back into the
cleaner being careful to feed the filter bag into the body of the cleaner.
MAKE SURE ALL FILTER
MATERIAL IS INSIDE THE CLEANER OTHERWISE THE LID WILL NOT CLOSE AND LATCH PROPERLY.
FIGURE 9
FIGURE 12
• Press the rear
section of the bottom
lid into the cleaner while
pushing the locking
clips towards the edge
of the cleaner until an
audible click is heard
as shown in Fig 10.
FIGURE 10
CLICK
• Once the bottom lid
is properly seated, turn
the red locking clips in
the opposite direction
of the arrows embossed
on the bottom lid until
it locks between the two
raised locks.
CABLE MAINTENANCE
UNCOILING THE CABLE
In the course of using your SmartPool Climber, the cord may begin to coil. Excessive coiling can lead
to improper cleaning coverage of your pool.
• To uncoil the cord, it is best that the cable is wet.
• Place the cleaner on the ground as shown in Figure 11.
• Be sure to use a clear area that will allow the cord to stretch out in a straight line.
• Pull the cable so it is off the ground
• Using your fingers, roll the cable in the opposite direction that it is coiled in.
• When straight, wrap cable for storage as shown in Figure 12.
STORING THE CABLE
• Loosely loop the cable as shown in Figure 12.
• Hold the cord close to the cleaner.
• Make a roughly two foot loop with the cord as shown.
• When making loop, roll the cable slightly in a counter-
clockwise manner to maintain form. DO NOT WRAP THE
CORD TIGHTLY AROUND OBJECTS.
The unit should be stored in an area that will afford some
protection from the elements to insure that it retains its finish.
Do
not store near open chemicals.
STORAGE
WINTER
SUMMER
If temperatures will regularly be below 45 degrees Fahrenheit or
5 degrees Celsius, the cleaner and power supply should be stored
indoors.
