6
Connecting the Filter System
CAUTION: If replacing an existing system, make sure to disconnect the old system and plug
the return and suction lines of the pool to prevent water loss.
1) Connect the suction hose from the pool to the front intake port of the Pump
Motor using a hose clamp (hose and clamp not supplied).
2) Connect the return line hose to the valve port marked RETURN and secure
it using a hose clamp (hose and clamp not supplied).
3) Remove any plugs from the return and suction lines, allow the system to fill
with water and check for leaks. Tighten clamps to close off any leaks.
4) Tighten the Strainer Cover Seal Ring (21) using Wrench (22) as shown in Figure 12.
Figure 12
OPERATION
Initial Start Up
1) Ensure proper amount of filter sand is placed in the tank.
2) Check that all connections are made and are secure.
3) Turn the valve to the Backwash position.
IMPORTANT: All suction and return lines must be open prior to turning the system
ON as failure to do so can cause a dangerous increase in pressure.
4) Turn the filter ON by plugging in the Pump Motor and let the system run for
1 minute to clear any impurities.
5) After 1 minute, unplug the pump and turn the valve to Rinse. Plug the pump
in and run for 30 seconds.
6) Unplug the pump, turn the valve to Filter and restart the pump.
7) Tighten any connections that may be leaking and adjust the return fitting in
the pool for desired flow.
IMPORTANT: Note the initial pressure gauge reading. Once the pressure gauge
reads 5 PSI greater than the initial reading, it is time to backwash the filter.
NOTE: Initial clean up or start up for the season may result in frequent
backwashing due to heavy debris loads.
NOTE: After initial start up procedures are followed, normal use of the filter system
can resume, running the system on the Filter position and Backwashing as
necessary.
Backwashing
1) Unplug the Pump Motor.
2) Turn the Valve to the Backwash position.
3) Plug the Pump Motor in and let the filter run until the water runs clear,
approximately 1-2 minutes depending on debris load.
4) Unplug the Pump Motor and turn the Valve to the Rinse position.
5) Plug the Pump Motor in and run for approximately 30 seconds to 1 minute.
6) Unplug the Pump Motor, turn the Valve to Filter and return to regular use of
the system.
