1.Turn off and un-plug equipment to be protected from wall outlet.
2. Plug the equipment into the
Copier Guardian II
.
3. Plug the
Copier Guardian II
unit into grounded wall outlet.
4. Your equipment is now fully protected. Place the
Copier Guardian II
where monitoring lights can
be observed.
Unit
INSTALLATION OF TBF™
Use the Standard CAT 5 Network Patch cord when using the Network protection RJ45 circuit.
Connected
Equipment with
Tel./Modem Jack
Power Cord
Power Cord
Pigtail
Outlet
Copier Guardian
Power Cord
Phone Cord
Phone Cord
Network Cord
Network Cord
LINE
LINE
DEVICE
DEVICE
Phone
Wall Jack
Network Jack/ HUB
Connected
Equipment with
Network Jack
Installation for Protection for Telephone Line and Network Cable
TELEPHONE
1. Unplug the equipment's telephone cable from the wall jack and plug into the RJ11 "DEVICE" on
the
Copier Guardian II
.
2. Plug the provided telephone cable to the RJ11 jack "LINE" on the
Copier Guardian II
.
3. Plug the other end of the telephone cable into the RJ11 wall jack.
Telephone Line Protection clamping voltage 250-350 vdc.
NETWORK
1. Unplug the equipment's network cable from the wall RJ45 network jack and plug into the RJ45
"DEVICE" on the
Copier Guardian II
.
2. Plug the provided network cable to the RJ45 jack "LINE" on the
Copier Guardian II
.
3. Plug the other end of the network cable into the wall RJ45 network jack. Your equipment is now
fully protected. Place the
Copier Guardian II
where monitoring lights can be observed.
NOTE
: All
Copier Guardian II
units come with security straps,
warning label and Velcro™ to secure unit to connected equipment.
STRAP FOR RECEPTACLE
STRAP FOR PIGTAIL
RECEPTACLE
The label on the security
strap is permanent and
warning: to unplug the unit
will cause the label to tear
out and void the warranty.
IMPORTANT: Velcro™ strips are provided so
Copier Guardian II
can be attached to copier
when needed. Do not place Velcro™ over label.
BACK OF UNIT
Provided with
Velcro™ strips
CAUTION
: - Never install telephone wiring during a lightning storm.
- Disconnect telephone line at the network interface before installing the secondary
protector.
- Intended for indoor use only.
The
GREEN
light confirms properly the connected equipment is fully protected. The
RED
light
indicates over voltage, improper ground connection or reversed power wires which needs to
be corrected. In an over voltage incident, power is disconnected to protect the connected
equipment.
IMPORTANT
: If the RED Light comes on, contact your electrician to inspect
and correct the outlet wiring in order to receive the maximum protection for your connected
equipment.
