Smart Power Systems Network Power Management System
6
6. Modify the IP, subnet mask or gateway address. Enter the new addresses into the
corresponding fields and then click
“Save”.
7. You will need to enter a User Name and Password for the Network Power Management Card in
the authentication window, as shown in Figure 3.
- Default user name:
admin
- Default password:
password
Figure 3. Authentication window.
8. If the IP address change is successful, you will see a message confirming the IP set up is OK, as
shown in Figure 4.
Figure 4. Setup IP Address successfully message.
9. In case the change is not successful, for example, if the IP address change is unsuccessful you
will see a warning message. Attempt to make the desired changes again. If the problem
persists please see the Troubleshooting section for help.
